Connection To The Rs232 Or Usb Communications Port (Optional); Connection To The Data-Line Protection Port (Optional) - MGE UPS Systems Pulsar Evolution 1100 Tower Installation And User Manual

2. Installation
A Pulsar Evolution 1500 tower UPS has been used below to illustrate the instructions. The principle is the same for all the
other tower and rack models.

2.4 Connection to the RS232 or USB communications port (optional)

Vac OUT
I max 12A

2.5 Connection to the data-line protection port (optional)

Vac OUT
I max 12A
Page 16 -
3400723200/AC
2 2
U.S. PAT. NO. 6,094,363
36Vdc, 9Ah
Pb
1
Reseau Volt 120V~1O
1 Mains Amps 12A MAX
Netz Hertz 50/60 Hz
Util Volt 120V~1O R
Load Hertz 50/60 Hz
Ausg W/VA 1000W/1440VA
34Z5
U.P.S.
344-50254-00
OUT IN
Data line protection
2
U.S. PAT. NO. 6,094,363
36Vdc, 9Ah
Pb
Reseau Volt 120V~1O
1 Mains Amps 12A MAX
Netz Hertz 50/60 Hz
Util Volt 120V~1O R
Load
Hertz 50/60 Hz
Ausg
W/VA 1000W/1440VA
34Z5
U.P.S.
344-50254-00
OUT IN
Data line protection
21
22
The RS232 and USB communica-
tions ports cannot operate simulta-
neously.
1 - Connect the RS232 21 or USB 22 com-
munications cable to the serial port or the
USB port on the computer.
2 - Connect the other end of the communica-
tions cable 21 or 22 to the RS232 2 or
USB 1 communications port on the UPS.
The UPS can now communicate with all
MGE UPS SYSTEMS supervision, set-up or
safety software.
The data-line protection function on the UPS
eliminates overvoltages flowing on the com-
puter-network lines.
Simply connect the line to be protected to the
UPS using the data-line protection connec-
tors (IN and OUT) as indicated opposite
(RJ45 cables not supplied).