Getting Started; Preliminary Checks; Connections; Power Connections - MGE UPS Systems 11+ User Manual

getting started

location
observe the safety rules indicated at the
beginning of this document.

preliminary checks

check that button 3 "
the front is not pushed in;
check that rating shown on identification
plate 10 corresponds to the input volt-
age specification and power requirement of
the load.

connections

power connections:

Pulsar ESV 22+ only: connect battery
connection cord 19 to Pulsar ESV 22+ and
connect to Pulsar EB22,
use the computer cord to supply input
power to Pulsar as shown.
1
2
g
n /E in
U e /I
mains
outlet
4
5
MGE UPS SYSTEMS
Connect the computer cord
the UPS power input receptacle
a nearby power outlet,
use included EEC cords
nect the computer loads to output sockets
" on 7 , 7a and 7b .
u s g
u t/ A
U s /O
1
2
to computer
7a 7b
systems
Note 1:
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button 3
Note 2:
The batteries will provide full back-up time
after approximatively 8 hours of recharge
time.
Note 3:
The rating of the input power cord must be not
less than the nominal input rating of Pulsar.
Pulsar ESV 8+/11+/14+/22+ EB 22/EB 22XLA : 86-153277-00

serial connections:

5 between
4 , and If you wish to use the functions of the
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
8 to con-
14 to the communication port 9 .
Connect the other end to a serial port of a
computer system.
7
computer network protection:
If you wish to use the network line filtering
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
8
" " .
11