Table of Contents
Advertisement
Event Record Mode Setup
When the DVR is set to record at an image rate lower than the maximum, it is possible to
change the recorded image rate and picture quality settings when an event occurs. When the
DVR senses an event on the Alarm Input port, it will change the image rate, picture quality
and continue recording at that rate for the user-defined length of time. Highlight Event
Record in the Main Menu and press the
Event Record Setup
Highlight the box beside Record Enable. Press the
NOTE: When Record Enable is set to Off, you will NOT be able to set Record
Speed, Image Quality or Dwell Time.
Highlight the box beside Record Speed and press the
speeds appears. You can select from 0.125 to 60 images per second for NTSC (0.152 to 50
images per second for PAL). The VCR equivalent speeds are listed with each setting.
NOTE: Make certain you select a record speed recognized by your multiplexer,
otherwise the DVR and multiplexer will not synchronize. Refer to your
multiplexer user manual for available record speeds.
NOTE: If you have set the DVR for Duplex mode, you will not be able to select
60 ips for NTSC (50 ips for PAL).
Highlight the box beside Image Quality and press the
You can select from Very High, High, Standard and Low image quality.
Record Enable
Record Speed
Image Quality
Dwell Time
Beep
Alarm Out
Alarm In Type
OK
Figure 38 — Event Record Setup screen
Single-Channel Digital Video Recorder
button.
Off
.
60 ips (2 Hours Mode)
High
10 sec
Off
.
Off
.
NC
.
Cancel.
button to toggle between On and Off.
button. A drop-down list of record
button. A drop-down list appears.
..
.
.
41
Advertisement
Table of Contents
