Chapter 3 - Configuration; Installing Hard Disk Drive; Figure 17 - Dvr Front Panel; Figure 18 - Hard Disk Drive Orientation - ADEMCO AHDR1 User Manual

Chapter 3 — Configuration
NOTE: Your DVR should be completely installed before proceeding. Refer to
Chapter 2 — Installation.

Installing Hard Disk Drive

Your DVR comes with a removable hard disk drive and you can purchase additional drives
from your supplier. Before turning on the DVR, you must install the hard disk drive.
1. Directly above the Front Panel Display is the hard disk drive door. Open the door by
pressing on the right-hand side of the door where it is labeled PUSH OPEN.
NOTE: The hard disk drive door cannot be opened when the power is on.
2. Open the case with the hard disk drive and remove the drive.
3. Holding the hard disk drive by the handle, slide it gently into the DVR until it stops.
(See Figure 17 for correct orientation.)
4. Close the door by pressing on the PUSH OPEN. This action slides the drive the rest
of the way into the DVR and completes the electrical connections.
Figure 17 — DVR front panel
Figure 18 — Hard disk drive orientation
Single-Channel Digital Video Recorder
21