Figure 37 - Time-Lapse Recording Schedule Screen - ADEMCO AHDR1 User Manual

Single-channel

Table of Contents

Highlight the box beside Record Speed and press the

speeds appears. You can select from 0.125 to 60 images per second for NTSC (0.152 to 50

images per second for PAL).

NOTE: The VCR equivalent recording speeds (in hours) are listed with each

setting. This is not an indication of how long the system will record video.

NOTE: Make certain you select a record speed recognized by your multiplexer,

otherwise the DVR and multiplexer will not synchronize. Refer to your

multiplexer user manual for available record speeds.

NOTE: If you have set the DVR for Duplex mode, you will not be able to select

60 ips for NTSC (50 ips for PAL).

Highlight the box beside Image Quality and press the

You can select from Very High, High, Standard and Low image quality. All other variables

being equal; Very High will require 600% more hard disk space than Standard, High will

require 250% more, and Low 30% less than Standard.

NOTE: Higher quality images require more storage space and will reduce the

recording capacity of the hard disk drive.

Highlight the box beside Recording Mode. Pressing the

and Timer. In the Manual mode, you must press the

Timer mode, the DVR starts recording based on the schedule you establish and the red LED

on the

button is lit.

REC

NOTE: If the DVR is set to Manual, you will not be able to set up a recording

schedule.

Highlight the box beside Schedule and press the

Time-Lapse Recording Schedule

Figure 37 — Time-Lapse Recording Schedule screen

0 2

¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡

Single-Channel Digital Video Recorder

button. A drop-down list of record

button. A drop-down list appears.

button toggles between Manual

REC

button to start recording. In the

button. A weekly calendar appears.

¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡¡

Cancel.

¡Active

Table of Contents