Erasing The Entire Homelink Memory (All Three Programs) - Toyota 2016 Highlander Service Manual

Erasing the entire HomeLink
Press and hold the 2 outside but-
tons for 10 seconds until the
®
HomeLink
changes from continuously lit
(orange) to
(green).
If you sell your vehicle, be sure to
erase the programs stored in the
®
HomeLink memory.
■
Programs stored in the HomeLink
●
The registered codes are not erased even if the battery cable is discon-
nected.
●
If learning failed when registering a different code to a HomeLink
that already has a code registered to it, the already registered code is not
erased.
■
Before programming
●
Install a new battery in the transmitter.
●
The battery side of the transmitter must be pointed away from the

HomeLink .
■
Certification for the garage door opener
This device complies with FCC rules part 15 and Industry Canada RSS-210.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference
that may be received including interference that may cause undesired opera-
tion.
WARNING:
The transmitter has been tested and complies with FCC and IC rules.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the device.
The term "IC:" before the certification/registration number only signifies that
Industry Canada technical specifications were met.
HIGHLANDER_U (OM48F09U)
6-4. Using the other interior features
®
memory (all three programs)
indicator light
rapidly flashing
®
memory
475
®
button
6