Erasing The Entire Homelink Memory - Toyota Prius 2007 Owner's Manual

WWW.MANUALS.WS
28p133
(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
For additional programming assistance
R
with your HomeLink Universal
Transceiver call the:
:
Toyota Customer Experience Center at
1−800−331−4331 (U.S.A.)
:
Toyota Canada Customer Interaction
Centre at 1−888−869−6828 (Canada)
312
WWW.MANUALS.WS
R
Refer to HomeLink on the internet at:
WWW.HOMELINK.COM
CAUTION
:
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
vent potential harm or damage.
:
Do not use this HomeLink
R
sal Transceiver with any
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any garage
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
R
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with Part 15 of the
FCC Rules and with RSS−210 of the IC
Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
R
(2) this device must accept any interfer-
ence received, including
that may cause undesired operation.
WARNING: This transmitter has been
tested and complies with FCC and IC
Rules. Changes or modifications not
expressly approved by the party re-
R
sponsible for compliance could void
Univer-
the user's authority to operate the
garage
device.
door
interference