Replacing The Fuse - Yamaha Neo's 4 YN50FU Owner's Manual

Hide thumbs Also See for Neo's 4 YN50FU:
Table of Contents

Advertisement

 KEEP THIS AND ALL BATTER-
IES OUT OF THE REACH OF
CHILDREN.
5. Check and, if necessary, tighten
the battery lead connections and
correct the breather hose routing.
To store the battery
1. If the scooter will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to "
", then disconnect
the negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check the
specific gravity of the electrolyte
at least once a month and fully
charge the battery whenever nec-
essary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure the key
PERIODIC MAINTENANCE AND ADJUSTMENT
is turned to "
the positive lead before con-
necting the negative lead.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals
and that the breather hose is
properly routed, in good condi-
tion, and not obstructed. NOTICE:
If the breather hose is posi-
tioned in such a way that the
frame is exposed to electrolyte
or gas expelled from the bat-
tery, the frame could suffer
structural and external damag-
es.
[ECA10602]
NOTICE
[ECA17711]
 Always
keep
charged. Storing a discharged
battery can cause permanent
battery damage.
 After installing the battery, be
sure to turn the main switch
from "
" to "
3 seconds intervals to initialize
the idle speed control system.
", then connect

Replacing the fuse

[ECA17721]
1. Main fuse
The fuse holder is located beside the
battery. Remove panel A to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
ECAM1120
lows.
1. Turn the key to "
the
battery
2. Remove the blown fuse, and then
" three times in
6-24
" and turn off all
electrical circuits.
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
NOTICE:
possibly a fire.
[EWA15132]
After removing and installing
EAUM3270
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents