Replacing The Fuse - Yamaha CW50E Owner's Manual

4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed. NOTICE:
breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas ex-
pelled from the battery, the
frame could suffer structural
and external damages.
PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing the fuse

If the
ZAUM0570
1. Battery
[ECA10601]
2. Fuse
The fuse holder is located behind panel
B. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
EAU23503
1 1 2 2
" and turn off all
[EWA15131]
6-19
Specified fuse:
7.5 A
3. Turn the key to " " and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
6