Table of Contents
Advertisement
Heat
Once a sufficiently high temperature rise has been detected after the heat-up
or refilling, the display changes to BURN and the combustion is automatically
controlled.
Reload
The optimal time to reload the stove towards the end of the burn-down phase
is indicated by a
red flashing
display.
red flashing
The
phase will appear, depending on environmental influences,
between 5-10 minutes. After reloading and closing the stove door, the display
changes to CHECK.
With sufficient temperature increase, the display changes back to BURN and
the combustion is again automatically controlled.
Note
If the display is not changing from IGNITE / CHECK to BURN within a
certain period after closing the combustion chamber door, the heating up
or reloading failed. So the required increase of the combustion chamber
temperature has not been reached. For a further heating, a new starting
process must be carried out.
Burn out
If during the
red flashing
phase the stove is not refilled, the combustion
chamber is cooled below the necessary temperature for refilling the
combustion chamber. The set time will be displayed again.
3. SPECIAL FEATURES
Child lock
To avoid an accidental start-up a child lock can be set up with a simple key
combination. If you press the plus button and menu more than 2 seconds at
the same time, the display indicates LOCK for a short time. The operation
of the keys is no longer possible, every keystroke is rejected again on the
display with LOCK. Press the combination Plus and Menu again longer than
2 seconds. The display UNLOCK appears for a short time and the key lock
is cancelled.
Fully closing of the air flaps
The Rikatronic4 has a safety device that prevents the air flaps from closing
completely during heating (deflagration). If the stove is not in operation, warm
air can escape through the chimney. A complete closure of the air flaps can
prevent this.
Make sure that the stove is cool and the combustion chamber door
Q
closed.
Keep the minus key pressed until CLOSED is displayed. The display
Q
backlight flashes while flaps are closing.
When the flashing stops, the air flaps are closed completely. The stove can
be switched off or the mains plug be pulled.
The flaps automatically open again if
the combustion chamber door is opened (with main power connected).
Q
an programed ignition time is reached (with main power connected).
Q
the power supply is restored.
Q
Note
From this point, no more wood should be refilled, because the lighting of
the new wood can no longer be guaranteed. A new fire lighting must be
carried out.
ECO-mode
After the first automatic burn cycle a heating mode with lower heat output is
possible. (see QUANTITY OF FUEL AT PARTIAL LOAD)
If you press the function key after refilling (during CHECK is displayed), the
display changes to ECO and Eco-mode is active.
E C O
In this mode, the combustion with a lower amount of fuel is also controlled
optimally.
Pressing the function key or by opening / closing the firebox door the ECO
changes back to BURN and the normal regulation is active again. The Eco-
mode must be activated again after each refilling.
Ignition Timer
This function allows a time-shifted automatic ignition within the next 24 hours.
16:00A
16:
ON
By pressing the ON / OFF button the programed ignition time can be activated
or deactivated.
Upon reaching the programed ignition time the ignition process is started
automatically. The display changes to IGNIT, the following combustion is
controlled fully automatically.
After each ignition, the programed ignition time has to be activated again.
Note
Please note that at the time of automatic ignition, a sufficient chimney draft
must be ensured. In a multiple use of the chimney, an automatic ignition
with the Rikatronic4 may only be carried out under the supervision of the
operator.
Tip
The activated ignition time is
:4 5 A
displayed with an additional A at
the end of time!
A
/ O F F
Advertisement
Table of Contents
