Table of Contents
Advertisement
2.2.1
Integrated Mirroring volume
The Integrated Mirroring (IM) feature supports simultaneous mirrored volumes with
two disks (IM).
The IM feature supports hot swap capability, so when a disk in an IM volume fails, you
can easily restore the volume, and the swapped disk is automatically re-mirrored.
To create an IM volume:
1.
Turn on the system after installing all SAS hard disk drives.
2.
During POST, press <Ctrl+C> to enter the SAS configuration utility.
LSI Corporation MPT SAS BIOS
MPTBIOS-6.20.00.00 (2007.12.04)
Copyright 2000-2007 LSI Corporation.
Press Ctrl-C to start LSI Corp Configuration Utility...
To avoid data loss, do not turn off the system when rebuilding.
3.
The following screen appears. Select a channel and press <Enter> to enter
the setup.
LSI Corp Config Utility
Adapter List
Adapter
SAS1064E
Esc = Exit Menu
Alt+N = Global Properties -/+ = Alter Boot Order
The numbers of the channel depend on the controller.
2-4
v6.20.00.00 (2007.12.04)
Global Properties
PCI
PCI
PCI
PCI
FW Revision
BUS
Dev
Fnc
Slot
02
00
00
20
1.24.00.00-IR
F1/Shift+1 = Help
Status
Boot
Order
Enabled
0
Ins/Del = Alter Boot List
Chapter 2: RAID configuration
Advertisement
Table of Contents
