Table of Contents
Advertisement
By default, the RAID Disk field shows No before array creation. This field is
grayed out under the following conditions:
•
The disk does not meet the minimum requirements for use in a RAID array.
•
The disk is not large enough to mirror existing data on the primary drive.
•
The disk has been selected as the Hot Spare for the RAID array.
•
The disk is already part of another array.
4.
Repeat step 3 to add the other disks to the volume.
When done, press <C> to create the array, then select Save changes then
5.
exit this menu.
Create and save new array?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
6.
The utility creates the array.
LSI Corp Config Utility
Processing...may take up to 1 minute
Creating RAID Array...
ASUS PIKE 1064E/1068E
v6.20.00.00 (2007.12.04)
2-11
Advertisement
Table of Contents
