Asus LSISAS RAID Card PIKE 1064E User Manual page 16

The Create New Array screen shows the disks you can add to make up the IM
6.
volume. Use the arrow key to select a disk, then move the cursor to the RAID
Disk column. To include this disk in the array, press <+>, <->, or <Space>.
You may also specify the Hot Spare disk here. Select the disk, then move the
cursor to the Hot Spr column, then press <+>, <->, or <Space>.
LSI Corp Config Utility
Create New Array -- SAS1064E
Array Type:
Array Size(MB):
Slot
Num
0
1
2
3
Esc = Exit Menu
SPACE/+/- = Select disk for array or hot spare
By default, the RAID Disk field shows No before array creation. This field is
grayed out under the following conditions:
•
•
•
•
2-6
Device Identifier
SEAGATE ST336754SS
SEAGATE ST336754SS
SEAGATE ST336754SS
SEAGATE ST336754SS
F1/Shift+1 = Help
The disk does not meet the minimum requirements for use in a RAID array.
The disk is not large enough to mirror existing data on the primary drive.
The disk has been selected as the Hot Spare for the RAID array.
The disk is already part of another array.
v6.20.00.00 (2007.12.04)
IM
------
RAID Hot Drive
Disk Spr Status
0003 [No] [No] ------- ----
0003 [No] [No] ------- ----
0003 [No] [No] ------- ----
0003 [No] [No] ------- ----
C = Create array
Pred Size
Fail (MB)
35003
35003
35003
35003
Chapter 2: RAID configuration