Acceptable Temperature Deviation Above The Desired Flow Temperature - Danfoss ECL COMFORT User Manual

Service parameter(s) 148
148 Acceptable temperature deviation above the desired
flow temperature (ΔT2
Circuit
(I) / (II)
The alarm is activated if the actual flow temperature rises too
much above the desired flow temperature. The max. deviation
ΔT2 is set here.
ALARM
This condition must last longer than the time interval Δt
(line 149).
This alarm can only be activated if the value in line 147 is set to
1 ... 30 K.
1 ... 30: The alarm function is active if the actual
Flow temp.
ΔT2
ALARM
30
The alarm signal can only be sent via the module ECA 80.
ALARM
Setting range
1 ... 30 K
temperature rises above the acceptable
deviation.
(line 148)
Desired flow temp.
)
Factory setting
No alarm if the
desired temp.
< 30 °C
Outdoor temp.
32u
(5) / (5) K
ALARM
°C
The grey
side of the
ECL Card