Advertisement
Quick Links
Instructions: Control Panel LCP 501
Instructions: MCD Control Panel LCP 501
Order Code: 175G0096
1. Description
The MCD 500 LCP can be mounted up to 3 metres away from the soft starter,
allowing remote control and monitoring. The LCP is rated IP65 when mounted
correctly in accordance with these instructions.
2. Packing List
1 x LCP
1 x Cable, DB9, 3 metres
1 x Gasket, foam
1 x Instruction sheet
3. Specifications
Maximum cable length
Protection
3 metres
IP65 and NEMA12
MI.17.G1.02 - VLT is a registered Danfoss trademark
4 x M3 x 16 Screw
4 x M3 Flat washer
4 x M3 Spring washer
4 x M3 Nut
2 x Jack screw
Advertisement
Related Manuals for Danfoss MCD LCP 501
Summary of Contents for Danfoss MCD LCP 501
- Page 1 1 x Gasket, foam 4 x M3 Spring washer 1 x Instruction sheet 4 x M3 Nut 2 x Jack screw 3. Specifications Maximum cable length 3 metres Protection IP65 and NEMA12 MI.17.G1.02 - VLT is a registered Danfoss trademark...
- Page 2 2. Apply the foam gasket to the back of the LCP. 3. Align the LCP over the holes and screw in place. 4. Plug the cable into the LCP and the soft starter. 177HA615.10 177HA616.10 MCD5-0021 to MCD5-0105 MCD5-0131 to MCD5-1600 MI.17.G1.02 - VLT is a registered Danfoss trademark...
- Page 3 If the parameter software version in the LCP is different from the software Starter to Display version of the starter, only will be available. While the LCP is synchronising, only the OK and OFF buttons are enabled. MI.17.G1.02 - VLT is a registered Danfoss trademark...
- Page 4 Instructions: Control Panel LCP 501 6. Mounting template Drill four mounting holes for screws (one in each corner) and two holes for the DB9 connector. 4 mm diameter 13 mm 25 mm 25 mm diameter MI.17.G1.02 - VLT is a registered Danfoss trademark...
Need help?
Do you have a question about the MCD LCP 501 and is the answer not in the manual?
Questions and answers