System Menu - ABB CP450 Installation And Operation Manual

Operation
7.2

System Menu

Set the dip switch SW7 = ON. After the self-test, the system menu of the
operator terminal is displayed on the screen:
The functions of the commands are briefly explained below:
System menu
command
Link
F2 - Confg
F3 - Copy
F4 - Set
F5 - Run
18
The operator terminal is connected.
Sets up the internal time clock and communication parameters
in the operator terminal. All the settings has to be made for the
operator terminal to work properly.
Use , , and
the value of the field.
Copies application data to another CP450.
Calibrates the touch screen and clears RAM data.
See also section 6 Touch Screen
Runs the application.
Function
to move to desired field; + and - to set
Calibration.
ABB, 1SBC159105M0202