Copying An Application - ABB CP450 Installation And Operation Manual

Operation
7.9

Copying an Application

To copy an application from one CP450 to another CP450, select F3 - Copy
from the system menu. Set the dip switch SW7 = ON and connect the two op-
erator terminals with a download cable. After the self-test, the system menu will
be displayed on the screen.
Select F3 - Copy in the system menu from the operator terminal with the appli-
cation to be copied. The operator terminal will prompt for a password: enter the
password set in CP400Soft from Application/Workstation Setup. Once the cor-
rect password is entered, the CP450 starts to copy the application to the other
CP450.
For information about setting a password, please see section 7.10 Passwords.
The following appears on the screens during the copying:
Note:
When copying for the first time, make sure to first run the application once, or
else the copy function will not work.
24 ABB, 1SBC159105M0202