Separating Front Bracket From Stator; Removing Pulley; Removing Stator - Mitsubishi S3Q2 Service Manual

2.6.1

Separating front bracket from stator

Do not disassemble the alternator unless the repair is
necessary.
Do not insert the screwdrivers too deep, as it can dam-
age the stator.
(1) Remove the through bolts.
(2) With two flat-head screwdrivers inserted between the
front bracket and stator, pry them apart.
2.6.2

Removing pulley

When setting the rotor in a vise, be sure to hold the
base of the rotor claw. Do not hold the rotor claw, as it
causes damage to the claw.
(1) Apply a cloth to the rotor and set it in a vise.
(2) Remove the pulley nut and then pull out the pulley and
spacer.
(3) Remove the rotor from the front bracket.
2.6.3

Removing stator

Unsoldering must be finished as quickly as possible.
Extended heating will damage the diodes.
(1) Cut off the joint of the stator and remove the stator from
the rectifier.
(2) Unscrew the rectifier mounting screws, and dismount
the rectifier.
ELECTRICAL SYSTEM
Separating front bracket from stator
Removing pulley
Rectifier
Soldering
Removing stator
Soldering
12-15