Everlast PowerTig 200DX-DV Operator's Manual page 27

Section 3
Basic theory and function
STICK OPERATION
STARTING METHODS
Tapping Method Scratch/Match Method
1. Turn on the power switch on the rear of the unit. Allow unit to cycle through its start up program.
2. Select the Stick mode with the HF/Lift Start/Stick selector switch.
3. Make sure electrode holder is hooked into the positive connector and the work clamp is hooked the nega-
tive connector.
4. Select the amps desired. Use the electrode diameter selection chart in this manual to determine the ap-
proximate range of amps suitable for the rod size selected. Consult the welding electrode manufacturer's rec-
ommendation for proper amperage range. Each manufacturer has specific recommendations for its elec-
trodes.
5. Use the arc force control to select the desired arc characteristics, creating the desired arc characteristic and
automatic amp response needed to maintain the arc when voltage falls below the threshold. 6011 Cellulose
electrodes will require more arc force control than other rods, but each brand and size will weld a little differ-
ently. The arc force control setting will vary from person to person as well, with different rod angles, posi-
tions, and arc lengths all factoring into the arc force control performance.
6. (Available late 2013) Adjust surge current to create a hotter start than the actual weld current to prevent
rod sticking and improve starting reliability.
6. Strike the arc with either the tapping method or the match strike method. Beginners usually find that the
match strike method yields best results. Professionals tend to gravitate toward the tapping method because
of its placement accuracy which helps prevent arc striking outside of the weld zone.
IMPORTANT: Do not weld in the TIG mode with the stick electrode holder still attached.
27