Everlast PowerTig 200DX-DV Operator's Manual page 10

Section 1
PowerTIG 200 DV TIG/Stick Welder
Process
Inverter Type
Minimum/Maximum Rated Output TIG
Minimum/Maximum Rated Output Stick
Start Type
HF Point Gap
TIG Duty Cycle @ Rated Amps/Volts
(US Version rated at 40° C)*
Stick Duty Cycle @ Rated Amps/Volts
OCV (U )
0
Voltage Input (U )
1
Maximum Inrush Amps (I
Maximum Operating Amps (Rated Effective) (I
Gas Pre-Flow /Post Flow Time
Down Slope
AC Frequency Control
AC Balance Control
Pulse Frequency Hz (Pulses Per Second)
Pulse Amps (Ratio)
Pulse Time On (Balance)
Stick Arc Force Control
Stick Surge Amp Control (Available late 2013)
Minimum Water Ingress Protection Standard
Efficiency
Cooling Method
Dimensions (rounded)
Weight (Bare Unit)
*Canadian version rated at maximum amps at 35% duty cycle @ 47° C (2014 Canadian standard)
Dual Voltage Model Optional. Standard model is 240 V only. Output Specifications for both models are same while operating on 240V.
)
1MAX
)
1EFF
Introduction and Specifications
AC/DC GTAW-P/DC SMAW
Analog, IGBT Construction
240 V: DC: 5 A/10.2 V - 200 A/18V AC: 20 A/10.8 V - 200 A/18 V
120 V: DC : 5A/10.2 - 120 A/14.8V AC : 20 A /10.8 - 120A/14.8V)
240 V: DC: 5 A/20.2 V - 160 A /26.4 V AC: 20 A/ 10.8 V-160 A/26.4 V
120 V: DC: 5 A /20.2 V -100 A/24 V AC: 20 A/20.8 V - 100 A/ 24 V
.030"-.045" (.035" suggested)
240 V: 60% @ 200 A/ 18 V; 100% @ 160 A/ 16.4 V
120 V: 60% @ 125 A/ 15 V; 100% @ 100 A/14 V
240 V: 35% @ 160 A/ 26.4 V; 60% @ 130 A/ 25.2 V; 100% @ 100 A/ 24.0 V
120 V: 35% @ 100 A/24 V; 60% @ 80 A/23.2 V; 100% @ 60 A/22.4 V
Dual Voltage: 120/240V 50/60 Hz 1 Phase
0-10 Seconds/ 0-25 Seconds
30-70% of Electrode Positive (EP)
Full Time High Velocity Fan with Tunnel design
18" H X 10" W X 25" L
10
Specification
HF and Lift Start
68V
34.6 A @ 220 V
39.3 A @ 110 V
24.4 A @ 220 V
26A @ 110V
0-10 Seconds
20-150 Hz
.5-150 Hz
5-95%
10-90%
0-100%
0-100%
IP21S
>85%
65 lbs