Advertisement
R
epair
(3) Insert a slotted head screwdriver between ring spring 21 and O ring case as illustrated in Fig. 11.
And push out the ring spring 21 from the inside groove of tool holder, with the slotted head screwdriver
(4) Insert 1R236 "round bar for arbor 7mm" in tool holder and remove the following parts from tool holder
by pressing with arbor press. See Fig. 12. After removing, clean the inside of tool holder in order to prevent
O ring's wearing away.
* Ring spring 21
* O ring case with O ring 11
* O ring 12
* Ring 12
* Impact bolt
1R236
"Round bar for arbor 7mm"
< 5 > Removing swash bearing 10
(1) Disassemble housing as per < 2 >, and then, take out the cam shaft unit from housing L.
(2) Remove ring 6 and ball bearing 626DDW with 1R269 "bearing extractor" as illustrated in Fig. 13.
In case may be, you can remove the ring spring 21 by hitting the screwdriver.
Fig. 11
Fig. 12
Fig. 12
Ball bearing 626DDW
Ring 6
Ring spring 21
O ring case
< Note >
Press "round bar for arbor 7mm" vertically.
Otherwise, impact bold can not be removed,
because "the round bar for arbor" may sticks
into the space between the tool holder
and impact bolt as illustrated in Fig. 12A.
Fig. 12A
1R269 "Bearing extractor"
Fig. 13
P 15 / 23
Advertisement
