Operating Instructions - Worx WX153 Safety And Operating Manual

OPERATING INSTRUCTIONS

Note: Before using the tool, read the instruction
book carefully.
BefoRe PUttING INto oPeRAtIoN
——BAtteRy cHARGING
A battery that is new or has not been used for a longer
period does not develop its full capacity until after
several charging / discharging cycles.
A significantly reduced working period after charging
indicates that the batteries are used and must be
replaced.
——to ReMove oR INStAll BAtteRy PAck
(See fig.A)
Locate latches on side of battery pack and depress both
sides to release battery pack from your tool. Remove
battery pack from your tool. After recharge insert the
battery pack into the battery port. A simple push and
slight pressure will be sufficient.
1. AUxIlIARy HANDle
(foR Wx165/Wx365/Wx365.1/Wx369/
Wx369.1/Wx369.2/Wx376/Wx376.1/Wx376.2)
Slide the handle onto the drill and rotate to the desired
working position. To clamp the auxiliary handle, rotates
the handgrip clockwise. To loosen it, rotate the handgrip
anti-clockwise. Always use the handle during operation.
2. oN / off SWItcH (See fig.B)
Depress to start and release to stop your drill. The on/off
switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
WARNING: Do not operate for long periods
at low speed because excess heat will be
produced internally.
3. SWItcH lock (See fig.B)
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of rotation selector in the center
position.
4. ReveRSIBle (See fig.B)
For drilling and screw driving use forward rotation
marked " " (lever is moved to the left). Only use
Cordless drill
WX153 WX158 WX165 WX365 WX365.1 WX369
WX369.1 WX369.2 WX376 WX376.1 WX376.2
A
B