Worx WX153 Safety And Operating Manual page 10

C
D1
D2
Cordless drill
reverse rotation marked "
right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction of
rotation when the chuck is rotating, wait
until it has stopped!
5. tWo-SPeeD GeAR tRAIN (See fig.c)
The drill has a two-speed gear train designed for
drilling or driving at LO (mark is 1) or HI (mark is 2)
speeds. A slide switch is located on top of the drill to
select either LO or HI speed. When using the drill in the
LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the
drill in the HI speed range, the speed will increase and
the drill will have less power and torque.
WARNING: to prevent gear damage, always
allow the chuck to come to a complete
stop before changing the direction of rotation or
the two-speed gear train.
6. cHUck ADJUStMeNt
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws. Finally,
firmly rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the chuck.
7. toRQUe ADJUStMeNt AND HAMMeR oR
DRIllING coNtRol (See fig.D-1 & D-2)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is
less when the torque adjustment ring is set on a lower
setting.
When drilling in masonry and concrete choose the
hammer position
WX369.1/WX369.2/WX376/WX376.1/WX376.2)
When drilling in wood, metal, plastic and screwdriver
choose the drill position .
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into soft and hard material
15 - 19 for driving screws into hard wood
20 - 23 for driving larger screws
WX153 WX158 WX165 WX365 WX365.1 WX369
WX369.1 WX369.2 WX376 WX376.1 WX376.2
" (lever is moved to the
. (for WX365/WX365.1/WX369/