Adjusting The Seat Angle/Seat Height - Invacare Dragon Service Manual

7.13

Adjusting the seat angle/seat height

There are three perforated plates under the seat for adjusting the seat angle and the seat height.
These perforated plates, in connection with the adjustable rear holding plates, result in a multitude
of different adjustment possibilities.
The adjustable range of the seat height (at 0° seat angle) is 42.5 cm to 50 cm. The adjustable
range of the seat angle is -12° to 22°. Please observe: The higher the seat adjustment, the smaller
the adjustable range of the seat angle!
Pre-requisites:
• 5 mm Allen key
• 6 mm Allen key
• 13 mm open-ended spanner
• Torque spanner
• Loctite (medium-hard)
•
The picture on the right shows the position of
the perforated plates (1) and the fastening
screws on the holding plates (2) for adjusting
the seat height and the seat angle.
The picture on the right shows the front perforated
plates. The approach is similar for the rear
perforated plates. To adjust the front perforated
plates a 13 mm open-ended spanner is required
in addition to the 5 mm Allen key.
•
To adjust the seat height/seat angle loosen
the screw (1) with the spanners and pull out.
•
Set the perforated plates to the desired
height/angle.
•
Apply the Loctite to the screw, re-insert the
screw and tighten to 40 Nm using the
spanners.
51