10. Refer to the printout from the Install Assistant (see page 3). Find the section
Don't use
CS (Cable Select)
Back view of the tape drive
Don't use
CS (Cable Select)
Installing the Hardware
labeled JUMPER SETTING? Set the jumper as advised.
TIP: You can use needle-nose pliers
if you need to move the jumper.
Slave
Check the back of your tape drive and
make sure the jumper is on the center
location (Slave-SL).
This is a jumper.
Green circuit
board is the top
of the drive
or Master
Check the back of your tape drive and
make sure the jumper is on the right-
hand location (Master-MA).
This is a jumper.
7