HP Colorado 5GB C4354A Installation Manual page 10

10
14. Refer to the printout from the Install Assistant (see page 3). Find the section
colored stripe on
the data cable
Installation Guide
labeled DATA CABLE INSTRUCTIONS?
Follow the instructions on the next page for either "One Device" or "Two
Devices" as advised.
TIP: If you are sharing the IDE data cable between the HP tape drive and
another device, when the HP tape drive is configured as "Slave" the other
device must be configured as "Master." Similarly, if the HP tape drive is
configured as "Master" the other device must be configured as "Slave."
CAUTION: Make sure that you are attaching the cable correctly! You must
locate PIN-1 on each connector and attach the cable so that the edge with the
color stripe is aligned with PIN-1. If the cable is attached incorrectly, your
computer may not boot up.
PIN-1
The cable's colored edge is aligned
with PIN-1 of the IDE connector.
PIN-1
The cable's colored edge is aligned
with PIN-1 on the tape drive.