18. Replace your computer's cover.
Plug your computer, monitor, and other devices into a wall outlet or
power strip and turn ON your computer. (The power plug and outlet may
look different in your country.)
TIP: If the drive is sharing the IDE controller with another device,
confirm that the other device is still working properly.
19. Now, insert the diskette labeled Run this first! into your floppy drive and
run the Install Assistant again to verify that the tape drive is installed
correctly.
For DOS and Windows 3.1:
Exit to the DOS prompt, type A:\ASSIST (where A: is
your floppy drive letter) and press ENTER.
For Windows 95 and NT 4.0:
Click on the Start button on the task bar, click on Run, type
A:\ASSIST (where A: is your floppy drive letter) and click on OK.
20. Run the Install Assistant program and select "Test...." if the program
doesn't select this automatically.
21. If successful, remove the Install Assistant diskette and go to page 16 for
instructions on installing the Colorado Backup software.
If you are having problems, continue.
Installing the Hardware
Computer ON
13