HP Colorado 5GB C4354A Installation Manual page 26

26
13. Refer to the printout from the Install Assistant program (see page 13) and
14. The Boot Drive dialog box appears prompting you for the drive from
15. A dialog box appears indicating that the software installation was
16. Exit Windows and, from the DOS prompt, reboot your computer by
17. Start Windows and double-click on the Backup icon in the new
Installation Guide
set each field as instructed, then click on OK.
I/O base address—A location in the computer's address space used by
the IDE controller to communicate between software and hardware
devices.
IRQ—The Interrupt Request (IRQ) channel is used by the IDE
controller to indicate to the computer that the drive is ready to send
or receive information.
Master/Slave —Two devices can be attached to each IDE controller,
one device set to "Master" and one device set to "Slave."
which your computer boots (starts). Make sure the correct drive letter is
entered and click on OK.
successful and that you must exit Windows and reboot your computer to
complete the configuration process. Click on OK.
pressing
CTRL+ALT+DELETE.
Colorado Backup group.
The following dialog box appears:
Note the instructions for
scheduling an automatic
system backup.