Table of Contents
Advertisement
34
Configuring the drive for Windows NT 4.0
1. Install your tape drive as directed in "Installing the Hardware" on page 4.
2. Start up your computer and log in with Administrative rights.
3. Go to the Control Panel and choose the Tape Devices icon.
4. Go to the Drivers tab and click on Add.
5. Windows NT creates a list of tape drivers. Click on the Have Disk button.
6. When prompted to enter the path for the manufacturer's files, type
7. Click OK.
8. A list of tape devices appears. Select Hewlett-Packard Colorado IDE. The
9. Restart the system when prompted. If no services fail, the drive is ready
10. Start the Backup application by clicking on Start, Programs,
11. Use NT Backup online Help to learn how to back up and restore data,
If You Have Problems
Installation Guide
Your HP Colorado tape drive can be successfully installed with Windows
NT 4.0. Use the backup application that is part of the standard Windows
NT 4.0 setup. Do not install the Colorado Backup software that came
with your tape drive.
(where D: is you CD-ROM's drive letter). If your computer does
D:\NT
not have a CD-ROM, see page 42.
necessary files are copied to your system.
to use. If services fail, please contact our QuickFax service for document
5228. The QuickFax phone numbers are listed on page 54.
Administrative Tools, and Backup.
compare files, and use the application's options and features.
If you receive any error messages when starting Colorado Backup, check
the following items:
Exit out of all applications. Turn off the computer's power, wait 20
seconds, then turn it on again. (This is called cycling power.) Then start
Colorado Backup.
Verify that your computer meets the requirements listed in
Hide quick links:
Advertisement
Table of Contents
