Subscribe to Our Youtube Channel
Related Manuals for Kentec Electronics Syncro
Summary of Contents for Kentec Electronics Syncro
- Page 1 Syncro Multi Loop Analogue Addressable Fire Control Panel User Manual Man-1057 Issue 09 June 2013...
-
Page 2: Table Of Contents
Each detection device is allocated a message of up to 40 characters (including spaces) to assist in the location of the devices. The Syncro control panel offers an extensive list of features and options for the control and monitoring of plant, equipment and sounders. -
Page 3: Safety
Fig 1 – Syncro Front Panel More Events This button is used to view all other suppressed events. In the case of multiple panel events or when any event information has been temporarily suppressed for menu navigation, this button is used to display the view events list. -
Page 4: Access Level 2
…………………………. Silence Alarm / Acknowledge This button is normally used to mute any fire warning sounders fitted to the Syncro panel. These sounders are installed throughout the protected premises and are used to evacuate the premises. In some cases, the fire warning sounders may be delayed; to allow a search time before building evacuation commences. -
Page 5: Panel Operation
The panel controls will now be enabled and will remain enabled for about 1 minute after the last key has been pressed. Pressing the Acknowledge Alarm button will now silence the sounders If the source of the event is a latching input, then pressing the Reset button will reset the system. Page 5 of 8 Product Manuals/Man-1057 Syncro User_09... -
Page 6: Alert Event
All detection devices, including manual call points, are disabled in the selected zone. NOTE: When a device is disabled, the Syncro panel ignores the analogue value reported by the device. All other faults for the device (missing device, double address, internal fault, type changed, bad data etc.) are still reported by the Syncro panel. -
Page 7: View Devices
Each zone may be individually put in to a Test Mode condition. When test mode is selected, the devices in the zone may be tested and the Syncro panel will automatically reset after 3 seconds. This is used for one man testing of the fire system. -
Page 8: Set System Time
To gain access to the panel printer, it is necessary to open the Syncro door and expose the internal components of the control panel, including the mains supply terminations. This makes it unsuitable for the end user to change the printer paper on this product.
Need help?
Do you have a question about the Syncro and is the answer not in the manual?
Questions and answers