Kentec Electronics Sigma XT+ User Manual

Kentec Electronics Sigma XT+ User Manual

Hide thumbs Also See for Sigma XT+:

Advertisement

Sigma XT+
Extinguishant Control Panel
User Manual
Man-1134
Issue 02 June 2013
*Man-1134*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sigma XT+ and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kentec Electronics Sigma XT+

  • Page 1 Sigma XT+ Extinguishant Control Panel User Manual Man-1134 Issue 02 June 2013 *Man-1134*...
  • Page 2 2.14 Turn on Extract output ........................4  2.15 Released condition ........................... 4  2.16 Low pressure switch ......................... 4  2.17 Manual only mode ........................... 5  2.18 Manual Release ..........................5  2.19 Abort input ............................. 5  Man-1134 Sigma XT+_ECP_02 Page 2 of 5...
  • Page 3 The yellow disabled LED on the module that has been disabled will be lit. Turn the Enable keyswitch off to leave the disablement active. To re-enable the Released relay output repeat the procedure above. Man-1134 Sigma XT+_ECP_02 Page 3 of 5...
  • Page 4 This will happen after the Extinguishant has been released but may happen before release through a leak. The fault LED on the ECU and on the detection part will light and the buzzer will sound when this input is operated. Man-1134 Sigma XT+_ECP_02 Page 4 of 5...
  • Page 5 Abort indicator on the ECU and the Extinguishant release timer will be cancelled i.e. the Extinguishant will not be released. The ECU can be immediately reset from this condition. Man-1134 Sigma XT+_ECP_02 Page 5 of 5...

Table of Contents