Table of Contents
Advertisement
Power button board
NOTE:
The power button board spare part kit includes the power connector cable.
Description
Power button board
IMPORTANT:
and replacement.
Before removing the power button board, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Base enclosure (see
c.
Display assembly (see
d.
Speakers (see
e.
Power connector cable (see
Remove the power button board:
1.
Disconnect power connector cable (1).
2.
Remove the one Phillips PM2×2 broad head screw (2) that secures the board to the keyboard/top cover.
3.
Remove the power button board from the base enclosure retention clips (3).
4.
Lift the power button board up at an angle and remove from the base enclosure (4).
Reverse this procedure to install the power button board.
Make special note of each screw and screw lock size and location during removal
Battery on page
Optical drive on page
Base enclosure on page
Removing the display on page
Speakers on page
Power connector cable on page
29), and then remove the following components:
30).
33).
51).
53).
Spare part number
806749-001
54).
Component replacement procedures
55
Advertisement
Table of Contents
