Remove the TouchPad:
1.
Release the TouchPad by tilting upward at the front (1).
2.
Pull the TouchPad away from the computer at an angle (2).
Reverse this procedure to install the TouchPad.
Removing the display
IMPORTANT:
and replacement.
Before removing the display, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Base enclosure (see
Disconnect the display:
1.
Disconnect the display cable from the ZIF connector (1) on the system board .
2.
Disconnect the ambient light sensor cable (2) from the system board.
3.
Remove the display cable from the clips in the routing path (3).
4.
Disconnect the WLAN antenna cable(s)(4) from the WLAN module.
Make special note of each screw and screw lock size and location during removal
Battery on page
Optical drive on page
Base enclosure on page
29), and then remove the following components:
30).
33).
Component replacement procedures
51