Setup; Ac Power; Fuse Replacement - Chauvet Intimidator Beam LED 350 User Manual

3. S
ETUP

AC Power

Fuse
Replacement
Intimidator Beam LED 350 User Manual Rev. 4
The Intimidator Beam LED 350 has an auto-ranging power supply and it can work with
an input voltage range of 100–240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
·
Always connect the product to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0–100% switch.
1. Disconnect the product from power.
2. Using a flat-head screwdriver, loosen the fuse holder and pull straight out.
3. Remove the blown fuse from the holder.
4. Replace with a fuse of the exact same type and rating.
5. Insert the fuse holder back in place and reconnect power.
Disconnect the product from power before replacing the fuse.
A spare fuse is not included.
Always replace a blown fuse with the same type and rating.
Page 7 of 20