Auto Detection Engine Function - Mercury SC1000 User Manual

BASIC OPERATION AND FEATURES
IMPORTANT: Performing a master reset will reset the unit to the
factory defaults, thus eliminating any installation and calibrations
performed during set up of product.
Press the "-" and "+" buttons simultaneously for approximately 10
seconds (until the graphic bars collide) to restore the unit to factory
default settings. Press the "MODE/SELECT" button to confirm.

Auto Detection Engine Function

The System
Tachometer come standard with an Engine Auto-detection feature.
This feature lets the gauge, on the initial power up, automatically
detect which engine type is used and configure the gauge to match
that engine type.
On first time power up of the gauge or after a Master Reset, the
gauge will display "AUTODETECT". Upon pressing the "MODE/
SELECT" button, the gauge will automatically determine engine
type. This will preset the data monitoring screens accordingly. The
intention is to make initial setup easier. Press the "MODE/
SELECT" button to start the Auto Detection Engine function.
If the gauge shows a warning of "NO STARBOARD ENGINE" or
"MULTIPLE STARBOARD ENGINES", the engine location must
be properly selected (Port and Starboard) at the engine using a
Mercury Computer Diagnostic System tool (CDS). Perform the
Master Reset and Auto Detect functions again. (Refer to Master
Reset).
MASTERRESET
MASTERRESET
ERASE CALIBRATION !
PRESS MODE/SELECT TO CONFIRM
Tachometer/Speedometer
AUTODETECT
ENGINE SMARTSCREEN
PRESS MODE/SELECT TO START
22660
and
24298
2
Smart Tow