Mercury SC1000 User Manual page 36

TACHOMETER CALIBRATION
CAL2 Tachometer Calibration - External Sensors
CALIBRATION 2
EXTERNAL SENSORS
TRIM SENSOR ?
[ NO ] [SAVE]
CALIBRATION 2
EXTERNAL SENSORS
SEA TEMP ?
[ NO ] [SAVE]
CALIBRATION 2
EXTERNAL SENSORS
STEERING SENSOR ?
[ NO ] [SAVE]
CALIBRATION 2
SPEED OPTION
[SKIP]
CALIBRATION 2
PITOT SENSOR
100 PSI TYPE
[ NO ] [SAVE]
CALIBRATION 2
PITOT SENSOR
MULTIPLIER = 1.00
[DOWN] [SAVE]
CALIBRATION 2
PADDLE SENSOR
PULSEFACTOR = 3.0
[DOWN] [SAVE]
CALIBRATION 2
TRANSITION SPEED
TRANSITION = 30 MPH
[DOWN] [SAVE]
CALIBRATION 2
DEPTH SENSOR
OFFSET = 3 FEET
[DOWN] [SAVE]
Is the boat equipped with a trim sensor? Press
YES
[YES ]
24009
Is the boat equipped with a water temperature
sensor? Press "-" to select no or "+" to select
YES
[YES ]
24010
Is the boat equipped with a steering sensor?
YES
Press "-" to select no or "+" to select yes.
[YES ]
24011
This section configures the following speed
sensors. Select "EDIT" to calibrate the sensors.
Select "SKIP" to proceed to the depth sensor
[EDIT]
24012
Select pitot transducer type. Choose between
100 or 200 psi. (100 psi is the most common)
[YES ]
24014
Adjust the pitot pressure sensor to correct
display readings that are too high/low. Press "-"
or "+" to calibrate the pitot sensor multiplier
[ UP ]
24018
Adjust paddle wheel frequency to correct
display readings that are too high/low. Press "-"
or "+" to calibrate the paddle sensor pulse factor
[ UP ]
24021
Set the speed at which the gauge stops reading
the paddle wheel and starts using pitot sensor
to measure boat speed. Press "-" or "+" to
[ UP ]
calibrate the transition speed down or up.
24022
Electronically configure a depth offset. Entering
a negative number gives you a water line offset.
A positive number gives you a keel offset. Press
[ UP ]
"-" or "+" to calibrate the depth sensor offset
24023
"-" to select no or "+" to select yes.
yes.
screen.
down or up.
down or up.
down or up.
32