Warning System With Descriptive Text; Alarm Warnings With Descriptive Text - Mercury SC1000 User Manual

WARNING SYSTEM WITH DESCRIPTIVE TEXT

Alarm Warnings with Descriptive Text

NOTE: Descriptive text alarm warning screens are displayed with
Gen I (2007) engines and newer.
3
2
RPM x 1000
1
0
SMART TOW
RESET
SELECT
When a problem is detected, the "SYS FAULT" alarm appears on
the display. Press the "+" button to show the faulty component. The
upper bar in this screen displays the system where the fault is
located. The faulty component is described in the scrolling text.
Press the "+" button for more information. This screen gives a
detailed description of the fault in the scrolling text. Press the "+"
button to view the required corrective action.
The alarm message will stay displayed until the "-" button is
pressed. If there are multiple alarms, press the "MODE/SELECT"
button to display.
If problem can cause immediate engine damage, the Engine
Guardian System will respond to the problem by limiting engine
power. Immediately reduce the throttle speed to idle and refer to
the warning messages on the following pages. Refer to the
appropriate service manual for further explanation of the problem
and the correct action to take.
If the "MODE/SELECT" button is pressed to display a different
screen, the flashing alarm signal "AL" will appear in the upper right
corner to indicate there still is a problem.
Alarm Warning with Descriptive Text
SYS FAULT
4
5
6
7
[ SHOW ]
24184
3 4
2 5
RPM x 1000
1 6
0 7
RESET
TROLL TROLL
-
+
MODE
The "SYS FAULT" bar indicates there is a
problem in the system. "SHOW" displays
the faulty component.
9
30 40
20 50
SPEED
10 60
0 70
RESET
TROLL TROLL
- +
MODE
22642