Mercury SC1000 User Manual page 29

SPEEDOMETER CALIBRATION
2. Press the "-" or "+" button to select the option choice displayed
in the [ ] brackets on the screen.
3. Press "MODE" ["SAVE"] to save the setting and advance
through the calibration selections.
CALIBRATION 2
EXTERNAL SENSORS
(SKIP)
CALIBRATION 2
EXTERNAL SENSORS
AIRTEMP ? YES
( NO ) (SAVE)
CALIBRATION 2
EXTERNAL SENSORS
GPS ? YES
( NO ) (SAVE)
CALIBRATION 2
EXTERNAL SENSORS
USE GPS SPEED ?
( NO ) (SAVE)
CALIBRATION 2
SEA TEMP
OFFSET =
(DOWN) (SAVE)
CALIBRATION 2
TROLL CONTROL ?
ENABLED
( NO ) (SAVE)
CALIBRATION 2
EXIT ?
( NO ) (SAVE)
EXTERNAL SENSORS
Selects and calibrates external sensors that are
installed in the system. Select [SKIP] for to
proceed to the next selection. Select [EDIT] to
(EDIT)
proceed to external sensor selection.
23569
Is an air temperature sensor installed? Press "-"
to select no or "+" to select yes.
( YES )
23574
Is a GPS sensor installed? Press "-" to select no
or "+" to select yes.
( YES )
23582
Use the GPS input to drive the speed display?
YES
Press "-" to select no or "+" to select yes.
( YES )
23596
Adjust the water temperature sensor to correct
display readings that are too high/low. Press "-"
0 F
or "+" to calibrate the temperature display down
( UP )
or up.
23592
To enable troll control select "YES" to disable
select "NO".
( YES )
23617
Press "MODE" to exit. Press "-" to go to the start
of CAL 2. Press "+" to continue to CAL 1.
( YES )
23618
25