Speedometer Cal 2 Calibration - Mercury SC1000 User Manual

SPEEDOMETER CALIBRATION
STEERING ANG. SCREEN ?
YES
[ NO ] [SAVE]
TEMP/CLOCK SCREEN ?
YES
[ NO ] [SAVE]
FUEL USED SCREEN ?
YES
( NO )
(SAVE)
TRIP SCREEN
YES
( NO ) (SAVE)
FUEL MGMNT SCREEN
YES
( NO ) (SAVE)
SIMULATOR MODE
NO
[ NO ] [SAVE]
SIMULATOR MODE
EXIT ?
[ NO ] [ YES ]

Speedometer CAL 2 Calibration

This calibration lets you configure the system sensor inputs.
NOTE: Screens may vary depending upon the version of the gauge
and your engine type.
1. Press and hold the "MODE" and "+" buttons simultaneously
for approximately nine seconds until the "CAL 2" display
screen appears.
DISPLAY SCREENS
The steering angle is displayed ("YES") or off
("NO"). The steering angle sensor must be set
to "YES" in the tachometer "CAL 2" external
[ YES ]
sensors calibration.
23542
The split screen showing air temperature and
time is displayed ("YES") or off ("NO").
[ YES ]
23543
The fuel used screen is displayed ("YES") or off
("NO").
( YES )
23544
The trip screen is displayed ("YES") or off
("NO").
( YES )
23545
The fuel management screen is displayed
("YES") or off ("NO").
( YES )
23546
SIMULATOR MODE
Enables the simulation mode. (Used for
demonstration purposes only).
[ YES ]
23547
EXIT
Press "MODE" to exit. Press "-" to go to the start
of CAL 1. Press "+" to continue to CAL 2.
[CAL 2]
23549
24