Second Winchester Drive Installation - Zenith Z-200 series Owner's Manual

Page
8.8
Installing Drives
D
Replace the cover following the instructions in Cover Replacement.
NOTE: Before using your computer, the SETUP program must be run.
Refer to The SETUP Program section in Chapter 1 of this manual. It
may also be necessary to run the PREP and PART utilities on the Winches­
ter. Refer to Chapter 2 for more information.
Second Winchester Drive Installation
Refer to Figure 8.6 for the following steps.
D
Unpack the new Winchester drive and mounting hardware that is
supplied.
D
Remove the resistor pack if installed.
D
Disconnect the two cables from the existing floppy disk drive.
D
Remove the screw holding the disk drive chassis on the rightside
of the computer.
D
Slide the disk drive chassis to the rear of the computer until it passes
the lip on the bottom of the main chassis.
D
Lift the disk drive chassis straight up out of the computer.
D
Place the new Winchester drive in the bottom of the disk drive
chassis and secure it with the four screws packed with the Winchester
drive.
D
Return the floppy disk drive on top of the Winchester drive and
secure it with the four screws.
D
Place the disk drive chassis with the newly installed drive back in
the computer and slide the chassis to the front. Make sure the drive
chassis catches the lip on the main chassis.
o
Reattach the screw to the front of the computer.