Control Keys - Zenith Z-200 series Owner's Manual

Page
1.12
Initial Setup
Control
Keys
The control keys are used in combination with other keys to perform
certain functions. Combinations using these control keys are explained
in Table 1.1.
ESC -
The escape key is used to stop the execution of a program/function
or to perform special functions when you press it in sequence with another
key. For example, if you want to enter ESC-E, press the
ESC
key, release
it, and then press the E key.
NOTE: When you do not want your computer system to autoboot a disk,
press the
ESC
key during autoboot (while the disk light is on). The system
prompt and message will appear in the upper-left corner of the monitor's
screen.
CfRL -
The control key performs special functions by pressing it with
another key simultaneously. For example, if you want to enter the CTRL-C
combination, press and hold the CfRL key and then press the
C
key.
ALT - The alternate key is used to enter special commands by pressing
it and another key at the same time. For example, if you want to enter
the ALT-A combination, press and hold the ALT key and then press the
A
key.
NOTE: The CTRL, ALT, and DEL combination will reset your computer.
All three keys must be pressed at the same time to return the computer
to the power-up point.
EJEJ
EJEJ
EJEJ
EJEJ
EJEJ
Figure 1.8. Control Keys