Floppy Drive Configuration B.l2 - Zenith Z-200 series Owner's Manual

Page
8.12
Installing Drives
360K Floppy Drive Configuration
There are two different models of 360K floppy disk drives available for
installation in the Z-200 PC Series Computer. Each of these two have
different jumpers to change for proper operation.
Compare your floppy disk drive to those shown in Figure B.8 and do
the following:
Drive Type #1 - Cut the tracer leading to pin 34 with a small sharp
knife.
Drive Type #2 - Cut the wire labeled RY.
Continue with Second Floppy Disk. Drive Installation explained earlier
in this appendix.