Winchester Drive Installation - Zenith Z-200 series Owner's Manual

Page
8.5
Installing Drives
Winchester Drive Installation
Before a Winchester drive may be installed, the cover of the computer
must be removed. Follow the instructions under Cover Removal in this
appendix. Make a note of the type of Winchester drive you are installing
according to the information printed on the bottom of the drive. If you
are installing a second Winchester drive, proceed to Second Winchester
Drive Installation later in this appendix. Before installing the Winchester,
verify that the drive select jumper is set at OSl.
Refer to Figure 8.4 for the following steps.
NEW
WINCHESTER
DRIVE
DISK DRIVE
CHASSIS
Figure 8.4. Winchester Drive Installation