Cable Connections B.lo - Zenith Z-200 series Owner's Manual

Page
B.10
Installing Drives
Cable Connections
Refer to Figure B.7 for the following steps.
D
Install one of the four connectors coming from the power supply
into the 4-pin plug on the left side of the new Winchester drive.
D
Position the ribbon cable assembly connected to the first Winchester
drive as shown with the colored stripe toward the power supply,
and install the connector on the disk drive circuit board of the new
drive.
D
Install one of the four connectors coming from the power supply
into the 4-pin plug on the left side of the floppy drive.
D
Reconnect the ribbon cable assembly to the floppy disk drive circuit
board.
D
Replace the cover following the instructions in Cover Replacement.
NOTE: Before using your computer, the SETUP program must be run.
Refer to The SETUP Program section in Chapter 1 of this manual. It
may also be necessary to run the PREP and PART utilities on the Winches­
ter. Refer to Chapter 2 for more information.