US Water Systems Aquapurion 5 Installation And Maintenance Manual page 14

1. Cut the 3/8" line that goes to the faucet and insert the 3/8" tee fitting.
2. Attach the 3/8" tubing that came with the kit to the open port on the tee.
3. Cut this tube about 2" after the 3/8" tee. Insert the shut off valve.
4. Attach the remaining 3/8" tubing to the other end of the valve.
5. Now run the 3/8" tubing to the refrigerator/ice maker close to the water inlet solenoid.
6. Once the tubing is routed to the refrigerator/ice maker, use the 3/8" to 1/4" adaptor to the existing 1/4" tubing on
the refrigerator/ice maker or use the 7/16" x 3/8" water inlet solenoid adaptor. If the solenoid adaptor is used,
remove the 1/4" existing line nut and sleeve, then screw the adaptor to the water inlet solenoid. No sealant or
teflon tape is required for solenoid adaptor. It is a compression fitting. Tighten the fitting and insert the 3/8" tub-
ing. Leave the ice maker off until the RO system is flushed and full.
7. When the RO system is full, turn on the ice maker shutoff valve and the ice maker shutoff lever or switch.
8. Disregard the first two batches of ice. This will flush the internal tubing in the ice maker or refrigerator.
9. If there is a filter in the refrigerator or ice maker be sure to bypass it or make sure it is change annually with the
RO system filter.
Flow Schematic is on the next page.
Ice Maker Kit Installation Instructions
Installation Instructions
Residential Reverse Osmosis Drinking Water System
Page 14