Following the instructions fully to this point you have success-
fully completed the following checklist:
❒
Located the base station properly.
❒
Connected power to base station.
❒
Connected the 1/2-wave antennas to the base station.
Checked frequency range of the antennas with the fre-
quency of the base station by correctly matching color
codes.
❒
Connected 1/4-wave antenna to the beltpack. Checked
frequency range of the antennas with the frequency of
the beltpack by correctly matching color codes.
❒
Base station transmit power switches in the correct po-
sitions.
❒
Transmit mode switch on beltpack set correctly
❒
Set wired intercom type correctly.
Pre-Walk-Thru Checklist
❒
Connected headsets to base stations (if needed) and all
beltpacks.
❒
Connected the base station to any auxiliary audio, in-
tercom or external P.A. system.
❒
Installed batteries in the beltpack.
❒
If you missed any of the above instructions, go back
and complete that instruction before going on.
5-1
S
ection
5