Installing The Switch On A Wall - Allied Telesis AT-8124XL Installation Manual

5. Connect the data cables, making sure each connection has a good valid link
and that the switch is receiving packets. For 10/100Base-TX ports, use a
straight-through cable to connect to workstations, servers, or printers. To
connect to a hub, router, or another switch, use port 24 and configure the
port as MDI using the uplink button or, alternatively, use a crossover
cable.
For additional details about the uplink push button on Port 24, see
Chapter 1.
6. Go to the procedure "Setting Up for Local Management" on page 17 to
access the management interface on the switch.

Installing the Switch on a Wall

To install the switch on a wall, perform the following procedure:
1. Remove all components from the shipping package and store the
packaging material in a safe location.
2. Attach the brackets to each side of the switch using the screws that came
with the switch package, as shown in Figure 1.
3. Select a wall location for the switch.
4. For wall-mount installation, you must supply the screws and wall anchors
or other material necessary to physically mount the switch to the wall.
Figure 2 Attaching the Brackets for Wall Mounting
AT-8124XL Fast Ethernet Switch Installation Guide
15