Enable/Disable Detector - Bosch BE 300 LSN User Manual

Enable/Disable detector

Notes on "Enable/Disable detector":
This is possible in the following chapters:
Display message
Display faulted points
View all detectors
It may only be done in coded mode. The areas must be dis-
armed.
1.
Call up the detector that is to be disable. Refer to the chapters on
the left for details.
2.
Press the "Code" key. Enter the user code and confirm your entry
with the "OK" key.
Malfun. 15:21
Detector 10
3.
Press the "Disable" key.
5
Disable
4.
Press the "OK" key. Detector 10 is disabled. Other detectors
can also be disabled with the "Disable" key.
OK
5.
Quit coded mode with the "Clear" key.
Clear
Enable:
When detectors are to be enable again, the steps are analo-
gous to disabling as explained here.
Disable
The " " key is then used to enable.
31
Disable
OK ?
Disable 15:21 C
Detector 10
NZ 300 LSN
BOSCH