Arming With Door Contact - Bosch BE 300 LSN User Manual

Arming/Disarming with BE 300 LSN (user code)

Arming with door contact

Note: Arming with a user code is only possible for pro-
grammed areas without a block-type lock. The areas must not
be on a walktest when activated.
1.
Press the "Arm" key.
2
Arm
2.
Enter the user code and confirm your entry with the "OK" key.
OK
3.
Use the paging keys to select the areas for activation. No se-
lection is necessary if there is only one areas (continue to
point 4).
Arm
Code ?
Arm
All areas
Arm
areas 2
4.
Press the "OK" key. Activation of the areas is started.
The door contact is not arm until after the arming delay. The
buzzer sounds at intervals during the delay (faster for the last
10 s). The room must be left in this delay.
OK
5.
Coded mode is no longer active after arming and the standby
image appears on the display.
11
Arm in 15 s
NZ 300 LSN
BOSCH