Elation Design LED 36MH User Manual page 17

Hide thumbs Also See for Design LED 36MH:

Table of Contents

Note: During start-up the Design LED 36MH™ will automatically detect whether a DMX data

signal is being received or not. If DMX data signal is being received, the display will show

"A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a DMX

signal the display will flash "A.XXX" (XXX representing the actual DMX address).

If your fixture is connected to a DMX controller and the display is flashing (not receiving a

DMX signal), please check the following:

The 3 PIN XLR plug (cable with DMX signal from controller) is not connected or is not

inserted completely into the DMX input jack.

The DMX controller is switched off or defective.

The DMX cable or connector is defective.

A DMX terminator has been inserted into the last fixture in your DMX chain.

Design LED 36MH™

Table of Contents